ok, cheers, i`ve added it, and check it installs to the correct place... but....

i build `multiple cabs`.... when its done i have :

blah_t1.cab
blah_t2.cab
blah_t3.cab
setup.exe
setup.lst

i copy the setups and the 1st cab to disk 1, then the _t2 and _t3 files to disk 2 and 3. the disks have no particular titles ( i just quick formatted them).

i click on setup.exe on the destination machine, and it goes through all 3 disks...then i get a choice of where to install them. i have deleted the old installation of this project so it asks me if it should create a dir - i say yes...then it starts copying...only to ask for disk 1 almost immediately. Why? Hasnt it just copied all the stuff to a temp dir or something? Otherwise, whats it been doing? And anyway, i`ve tried putting in disk 1,2 and 3 and clicking ok and it still asks for disk 1!

I`ve been MicroShafted!!!! Help!
Alex.