Designer file gets messy

[namrekka]

My project gets rather big. Now sometimes when loading the design file I get this error. But the project compiles without any problems and runs fine. Some one any idea where to start or what to do?

[kleinma]

When you get that error, if you then close the open documents, and do a rebuild, are you able to open the form normally in the designer?

[namrekka]

After a rebuild I can open the designer. But after a run or debug I can't load the designer.

[namrekka]

Hmmm... have cleaned the bin and the obj folder now its ok again.

[techgnome]

I get that once in a while... I find a simple rebuild is all it takes. I only worry about it when even a rebuild doesn't work.

Worst case, I shut down VS, re-start it, open the solution, compile, then open the designer file.

-tg