|
-
Nov 4th, 2000, 04:47 PM
#1
Thread Starter
Member
Hi, i'm getting no errors during design time (using the run command) and yet after compile, I get a "run time error '9' Subscript out of range".
Why no error, yet there is error? 
-
Nov 4th, 2000, 04:48 PM
#2
Fanatic Member
Can you post the code that has the error?
-
Nov 5th, 2000, 12:46 PM
#3
Thread Starter
Member
hmmm....the whole thing has almost 2000 lines of code.......
i doubt you'd want to follow it 
this has never happened to anyone?
perhaps i need to get a service pack
(VB 6 enterprise w/ no service packs)
-
Nov 5th, 2000, 12:57 PM
#4
Hyperactive Member
you prolly exceeding an array bound. Check 'em.
td.
"One logical slip and an entire scientific edifice comes tumbling down." - Robert M. Pirsig
[email protected]
"but if Einstein is right and God is in the details, reality requires that we sometimes get religion." - Scott Meyers.
-
Nov 5th, 2000, 04:09 PM
#5
Thread Starter
Member
but
but why does it only occur after I compile it?
It does not happen when i'm doing the running it by interpreting...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Click Here to Expand Forum to Full Width
|
Reply With Quote