Okay....back to the same old stuff. I just installed VB6 (from Visual Studio 6.0 Enterprise CDs) on another Win10 computer. I want to remove VB6 (or VS6.0, if ya will) from one of the other Win10 computers in my office. However, on THAT computer, it never installed correctly (the old 'hanging when installing' issue). And was hence never able to get SP6 installed on that computer either because of the 'failure' of a proper VB6 install (although VB6 'worked fine' for what I needed). VB6 was never shown in the Control Panel listing of installed programs, so I was unable to select it and uninstall.
So, I attempted (3x) to reinstall VB6 from 'scratch' from my original CD set. Each time it failed. So, what I would like to do is UNINSTALL VB6 from that computer, but haven't a clue on how to do it (running the 'Install' program again to deselect (which I never get to) Visual Basic 6.0, ends with a message saying it was not installed.) However, the current 'bad' install I have been using for a couple of years still 'works'.

I found this on the internet, and have NOT tried it, because it seems like it is what I am doing with the Setup.exe wizard:

In order to uninstall VB6, run this command: "C:\Program Files\Microsoft Visual Studio\VB98\Setup\1033\Setup.exe"

1-does that make sense?
2-How else might I get VB6 off that computer?

Ultimate goal is to reinstall VS6 (only the VB6 component) on that computer (along with MSDN and SP6), but can't do it with that older install on the system.

Any other information ya might need to advise?

Sammi