I may be getting in way over my head, but here it goes. I am developing a small application for use on a helpdesk. The application will be installed on the client pc's and will be used primarily by the end user to assist the technician on the phone if the user's pc is offline or inaccessible. One part of the application gives the user their IP address, DNS address, DHCP address, and gateway address. I have it to where it will put all of those in the corresponding fields inside a form, but it does not work correctly outside of a domain. Outside of a domain it only gives the IP address. I am sure it is probably how I coded it, but I cannot think of any other way to get that info in a user friendly way. Is there a way to parse a command prompt command to specific fields inside of a form such as the command ipconfig /all? That way it would always give the correct info regardless if they are on a domain or not. If you would like to see my code because it would help you help me, then just let me know. Thanks in advance. You guys rock!