Results 1 to 3 of 3

Thread: [RESOLVED] CR11 and Mailing Labels

  1. Jan 29th, 2007, 09:22 AM #1
    Besoup
    Besoup is offline

    Thread Starter
    Frenzied Member
    Join Date
    Nov 2001
    Location
    Mass USA
    Posts
    1,674

    Resolved [RESOLVED] CR11 and Mailing Labels

    Hey,
    I am trying to design a report that will print the same data on each section of Avery 5160 label paper. I am just planning on passing the report 3 parameters. My question is, how to I duplicate them to go into each label. Right now it only goes into 1 label and the rest stay blank.

    Thanks for any help!
    Reply With Quote Reply With Quote
  2. Jan 29th, 2007, 06:44 PM #2
    brucevde
    brucevde is offline
    PowerPoster
    Join Date
    Oct 2002
    Location
    British Columbia
    Posts
    9,758

    Re: CR11 and Mailing Labels

    Did you use the Mailing Label Expert Wizard? Avery 5160 is a preset label (at least it is in version 8.5) and if you used the wizard everything would be setup for you.

    [edit] Sorry, I think I misunderstood the question.

    You want to print the address multiple times instead of just once, ie fill the entire label sheet with the same label.
    Last edited by brucevde; Jan 29th, 2007 at 07:02 PM.
    Reply With Quote Reply With Quote
  3. Jan 30th, 2007, 08:06 AM #3
    Besoup
    Besoup is offline

    Thread Starter
    Frenzied Member
    Join Date
    Nov 2001
    Location
    Mass USA
    Posts
    1,674

    Re: CR11 and Mailing Labels

    yeah I am using a temp table for the datasource so i just went and put duplicate lines in it for now....
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Click Here to Expand Forum to Full Width