Results 1 to 2 of 2

Thread: Configuration problem in VS 2005 ?

  1. Mar 31st, 2006, 10:50 AM #1
    maitung
    maitung is offline

    Thread Starter
    Junior Member
    Join Date
    Dec 2005
    Posts
    18

    Configuration problem in VS 2005 ?

    Hello everyone, my VS 2005 is fresh install (without 2003 before).
    When I try to debug any program, the following error appears:

    Error while trying to run project: Unable to start debugging.
    The binding handle is invalid.

    Even it is a new project with only one form, nothing on it.

    I guest there is some problem with the Debug config, 'cause I see there is AnyCPU, x86, x64 in the field next to "Debug" combo box. I tried them out but still doesn't work.

    Anyone got experience on this matter, plz tip me, thanks.

    (I post here because there is no forum for .NET IDE in general)
    Reply With Quote Reply With Quote
  2. Mar 31st, 2006, 12:14 PM #2
    bgard68
    bgard68 is offline
    Addicted Member bgard68's Avatar
    Join Date
    Mar 2006
    Location
    Arkansas
    Posts
    164

    Re: Configuration problem in VS 2005 ?

    Check out:
    http://www.dotnetslackers.com/Debugg..._Resolved.aspx
    Using Framework 1.1, VB.Net 2003 unless I
    state otherwise
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Click Here to Expand Forum to Full Width