-
Jul 24th, 2021, 09:11 AM
#1
[RESOLVED] Playing sound waves in IDE and Exe
Strangest thing this morning....
I've been using a JukeBox program I created about 10 years ago (and have been modifying over the years). Up until today, EVERYTHING worked as it should.
When I run my last executable(s), I hear the music being played on my speaker system. However, starting this morning, when I opened the project and ran it, I do not hear any music.
The Executable was created immediately after any changes were made in the IDE. (I even copied the entire project to another computer). Running the executable on the other computer works fine just like the executable on the original computer. But, running from the IDE on that second computer, same thing, no sound.
SO, I went to a back up of a few months ago and ran the executable...also works fine, but using THAT backup project IDE, no sound.
So, basically, in all copies of my Jukebox program, it works in the executables, but not the IDE.
WHATEVER could be the issue here?
(Other projects I have using the MMControl (as in the Jukebox program) work fine in both IDE and Exe.)
Sam I am (as well as Confused at times).
-
Jul 24th, 2021, 09:30 AM
#2
Re: Playing sound waves in IDE and Exe
Do the compiled programs play the music when you run them elevated?
Aside from that I'm not sure what might be different.
-
Jul 24th, 2021, 09:30 AM
#3
Re: Playing sound waves in IDE and Exe
you need upload project vb code
-
Jul 24th, 2021, 09:41 AM
#4
Re: Playing sound waves in IDE and Exe
xi---can't WAY FAR TOO MANY LINES OF CODE
dile---Interesting...used a THIRD computer I had a recent copy and it ran fine on both IDE and EXE.
Copied the entire thing to my main computer...nothing in IDE. SO, when I said above about that second computer, I actually ran it (in both IDE and EXE) FROM my main computer, I didn't go to my game room where that computer is located. (will do that while I reboot my main computer...as that is the ONLY thing I think is different.)
So, going to reboot. Test on this and 2nd computer, and then post results.
Sam I am (as well as Confused at times).
-
Jul 24th, 2021, 10:59 AM
#5
Re: [RESOLVED] Playing sound waves in IDE and Exe
Here WAS the issue....
The volume (under Settings, Sounds, etc) for the Jukebox program was 'somehow' set to 0 (I moved slider to the right...all is working fine).
I usually don't mess with sound settings (and definitely haven't in past few days), so don't know why it was reduced to zero.
Oh well, lesson learned.
Sammi
Sam I am (as well as Confused at times).
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Click Here to Expand Forum to Full Width
|