[RESOLVED] Picture too small

I have problem here..

The picture display to small. How I can large the picture?

My scale mode is - Twip

Code:

---

Form5.legMapDisp.ExportToBmp (App.path & "\output.bmp")
Printer.CurrentX = 600
Printer.CurrentY = 12000:
'print legend
Printer.Print "Legend": ForeColor = vbBlack
Set Picture2 = LoadPicture(App.path & "\output.bmp")
Printer.PaintPicture Picture2, 60, 13000, 2000, 800

---

How big (Width/Height) and where (X/Y) do you want to Print it?
This should center the Picture in the sheet (using Twips, real size, no streching)

Code:

---

    Printer.PaintPicture Picture2, _
            Printer.ScaleWidth / 2 - ScaleX(Picture2.Width, vbHimetric, vbTwips) / 2, _
            Printer.ScaleHeight / 2 - ScaleX(Picture2.Height, vbHimetric, vbTwips) / 2
                       
    Printer.EndDoc

---

That good.That what I needed.So How I can move the picture by its X and Y location?

Code:

---


Printer.PaintPicture Picture2, _
            Printer.ScaleWidth / 2 - ScaleX(Picture2.Width, vbHimetric, vbTwips) / 2, _
            Printer.ScaleHeight / 2 - ScaleX(Picture2.Height, vbHimetric, vbTwips) / 2

---

Printer.PaintPicture YourPicture, X, Y - 2nd and 3rd parameters are X and Y.

You can also use Printer.CurrentX and Printer.CurrentY to move to any position.

If I put like that it streaching.Right now, the picture show at the center. i just want to move this location but not involved too much changing of the picture location.At the same time I also want to preserve the picture behavior.

Code:

---

Printer.PaintPicture Picture2, 60, 13000, _
            Printer.ScaleWidth / 2 - ScaleX(Picture2.Width, vbHimetric, vbTwips) / 2, _
            Printer.ScaleHeight / 2 - ScaleX(Picture2.Height, vbHimetric, vbTwips) / 2

---

That code is not correct, you added my code in the wrong place, that is suposed to center the picture using parameters 2nd and 3rd, not parameters 4th and 5th, 4th and 5th must be used to stretch, that's another thing.
I don't know what you mean by: "want to preserve the picture behavior."

I assume your X = 60 and Y= 13000 are ok, that must be where you want the Picture to be.
Now, if you want to Stretch it (make it smaller or bigger) keeping the Picture Ratio (maybe you meant this when you said behavior) use something like this:

Code:

---

    Dim lStretch As Single
   
    lStretch = 0.5 'How small/Big it will stretch
   
    Printer.PaintPicture Picture2, 60, 13000, _
        ScaleX(Picture2.Width, vbHimetric, vbTwips) * lStretch, _
        ScaleX(Picture2.Height, vbHimetric, vbTwips) * lStretch
       
    Printer.EndDoc

---

If you change the value in lStretch, the Picture Size should change.