[RESOLVED] [2005] Array Problem

Hi,
I have the following definition

Code:

---

Dim nMembers As Int32()

ReDim nMembers(6)
nMembers(1) = oStd.Geometry.AddBeam(nNodes(1), nNodes(2))
nMembers(2) = oStd.Geometry.AddBeam(nNodes(2), nNodes(3))
nMembers(3) = oStd.Geometry.AddBeam(nNodes(3), nNodes(4))

nMembers(4) = oStd.Geometry.AddBeam(nNodes(4), nNodes(5))
nMembers(5) = oStd.Geometry.AddBeam(nNodes(5), nNodes(6))
nMembers(6) = oStd.Geometry.AddBeam(nNodes(6), nNodes(7))

Dim omembList As Object
omembList = nMembers

oStd.Design.AssignDesignParameter(refBrief, "FYLD", "345000", omembList)

---

The Code

Code:

---

oStd.Design.AssignDesignParameter(refBrief, "FYLD", "345000", omembList)

---

gives me the following output

Quote:

---

FYLD 345000 MEMB 0 TO 6

---

Where as desired output is

Quote:

---

FYLD 345000 MEMB 1 TO 6

---

it should be MEMB 1 to 6 instead of MEMB 0 to 6

Will be thankful for any feedback

.NET arrays are zero-based. By doing this:

vb Code:

ReDim nMembers(6)

You are creating an array with 7 elements at indexes 0 to 6. If you want an array with 6 elements then you would have to do this:

vb Code:

ReDim nMembers(5)

and set the elements at indexes 0 to 5. You would, of course, have to allow for the offset when creating your output.

If the fact that you need to specify the upper bound rather than the length when creating an array confuses you then I suggest that you make a habit of creating arrays using the length - 1, e.g.

vb Code:

ReDim nMembers(6 - 1)

Hello jmcilhinney,

Many thanks for your prompt response.
Is there a way to set the index of an array to start with 1 instead of 0.

thanks

Quote:

---

Is there a way to set the index of an array to start with 1 instead of 0.

---

I think that it is not good, If you want to avoid the zero position then simple do not use it and put a blank value there.
But it is not good programming.

Hello Shakti,
You are probably right!

I remember setting the index to 1 in VB6.0, just wondering if there is some way of achieving the same in VB.Net

There is one way but I wouldn't recommend it because you end up with an Array object rather than a typed array:

vb Code:

Dim arr As Array = Array.CreateInstance(GetType(Integer), _
                                        New Integer() {6}, _
                                        New Integer() {1})

Unless you're unable to change the implementation of this AssignDesignParameter method then I suggest that you code "properly" and use zero-based arrays and account for the fact whenever using indexes.

I will change my code to 0 index and revert back shortly..

thanks again...

Ok, Was able to set the index to 0 and recode.
Many for your valuable inputs...