Printable View
Hi every one
I have three pc 2 laptop and 1 desktop I want my two laptops to be connected to my network by wireless ..
But when I enable the WEP protection the laptop cannot connect .(they can only connect when the Authentication is disabled )
So I am planning making an application (in vb.net) that promts the user when ever they connect to my network and I have no clue where to start
Any help would be great thx
Why not just update the drivers on the laptop so that it can handle WEP? It's not usual practice to write code to get around deficiencies in outdated drivers.
thx but I alredy did and now it says my hard drive is fully updated and it cannot find a better update ...
:( :(
Any help
??
Enable WEP. Set the network passcode, and note the Network Key code it generates.
Open your Network Connection and find the Wireless Network Connection, right-click, select properties.
Click the Wireless Netwroks tab (should be in the middle).
Under preferred networks, find your lan. It maybe disabled, but that's OK.
Select it and click Properties.
Make sure the SSID is correct.
Set the Network Authentication to Open, and select WEP as the encryption.
Enter the Network key.... and again.... if you used the first key in the list the router gave you, then leave Key Index alone.... if you selected any of the others, change it.
Click OK.
It should now connect.
It's worked for me, so I don't see why it shouldn't in this case.
-tgq
thx any way I diabled the some stuff
it works now