Crystal 8.5 Preprinted Forms with Subreports

I am modifying a vb6 application that prints on a preprinted form using Crystal Report 8.5.

The report has a main report and a subreport.
It is basically an Invoice with Header Data(Main Report Top Half of Form) and
Detail Data(Sub Report with 6 sections - Bottom Half of Form).

Currently, the sub report is allowed to grow so that if there is too much detail information it will print on the second page.

The problem is that when the subreport grows it prints on the top of the next page and overwrites on top of parts of the preprinted form reserved for header data.

Is it possible to get the overflow to print on the second page only in the area reserved for the subreport data.
Also can the subreport break at the top of a section inside the subreport.
each section represents a different type of detail data.

Any suggestions on how to proceed?

Thanks

Which Sections are you utilizing for each report? Which section does the sub-report print?

It might be simply a matter of inserting an additional Page Header section (PageHeaderB) onto the Main Report that does not contain any fields. Set the height of the PageHeaderB section equal to the top half of the report. Suppress it if the Page Number = 1 and suppress PageHeaderA if the Page Number > 1.

There are other methods but again they would depend on which sections you are using.

Main Report Sections
---------------------
Report Header Sect 1 - Greyed Out
Page Header Sect 2 - Greyed Out (Key Sorting)
Group Header #1 Sect 10 - Greyed Out (Key Sorting)
Group Header #2 Sect 6 - (Key Sorting)
All Header Data being Printed
Sub Report is Embedded Here as well

Detail Sect 3 - Greyed Out
Group Footer #2 Sect 7 - Greyed Out
Group Footer #1 Sect 11 - Greyed Out
Report Footer Sect 4 - Greyed Out
Page Footer Sect 5 - Greyed Out


SubReport Sections
---------------------
Report Header Sect 2 - Greyed Out
Group Header #1 Sect 7 - Sequence Data A
Detail Sect 3 - (Key Sorting) Data
Group Footer #2 Sect 8 - Data

Report Footer a Sect 9 - Data
Report Footer b Sect 1 - Data
Report Footer c Sect 5 - Data
Report Footer d Sect 6 - Data


Also, Anyway to renumber the Section # so they don't jump around?

Group Header #2 will probable need to be broken up since Header Data and the Sub Report are Embedded here
The Form Prints Like this
HHHH
HHHH
XSSS
SSS
SSS

H=Header Data, X=History Data(Part of Header), S=SubReport Data

Quick Note The SSS should all line up. When it saved my reply it shifted the SSS that were below the X to the left.
HHHH
HHHH
XSSS
..SSS
..SSS
Where .. is blank area