[RESOLVED] winNT4.0 server installation help
hello there..im having trouble getting my winNT4.0 server installed.
after it has written the set-up disks into the 3 diskettes, it wont continue while reading setup disk#2.. the system would restart and obviously will prompt the error "Non-system error"..
ive tried using 20G and 1G partition, but still wouldnt work.. :( ive also tried downloading new files in a hope that my Installer might be deffective...still in vain...can anybody help me? pls? :confused:
Re: winNT4.0 server installation help
Did you try using another disk for disk 2? Maybe it's bad.
Re: winNT4.0 server installation help
If your using FAT32 for your file system NT4 can only see up to 4 gigs per partition. Yes, its more then likely that the floppy is bad or its a bad copy. Change the physical floppy disk and regenerate a new set. ;)
Re: winNT4.0 server installation help
hello, thanks for your replies.
ive already tried using new floppy disks.
and ive also tried downloading the set-up disks files but still got the same result.
could there be some hardware problems here?
Re: winNT4.0 server installation help
Try doing a fdisk and reformatting your hd. Doesnt matter if its fat32, only trying to see if it can be formatted and then after that see if you can run a chkdisk on it for a possible bad cluster or sector. ;)
Re: winNT4.0 server installation help
the HD im using is a new one...so im not really sure if it is that cause..bt will try to run chkdisk... :)
thanks again...will try to give an update as soon as i finish checking.. :blush:
Re: winNT4.0 server installation help
One last possibility is that you have a incompatible hardware device. Something that may not be on the HCL at MS or it could also be a bad copy of NT4 Server. Is it legit?
Re: winNT4.0 server installation help
there has been no error found.... :( what else can I do?
btw, ive tried reformatting 3 times.. :(
Re: winNT4.0 server installation help
Quote:
Originally Posted by RobDog888
One last possibility is that you have a incompatible hardware device. Something that may not be on the HCL at MS or it could also be a bad copy of NT4 Server. Is it legit?
yes it is an original copy.. :D
Re: winNT4.0 server installation help
Make sure you only have the bare necessities connected to your system during installation. No printer, no usb (NT4 doesnt support usb), COM port devices etc. as they may cause a conflict during installation. ;)
Re: winNT4.0 server installation help
ive already checked it...there's no other devices connected to the pc now. :(
could a higher memory be a problem? :cry:
Re: winNT4.0 server installation help
You may need to check on the microsoft site for the Hardwarre Compatibility List. This shows what hardware is certified to run each version of Windows. If the install is hanging and its a genuine CD then it must be a hardware compatibility issue. ;)
Re: winNT4.0 server installation help
the system would restart while reading setup disk2
specficially while it is loading FAT File System.
thanks for the replies RobDog888..
i will check on the hardware specs on this...
thank you kaayu(very much).. :blush:
Re: winNT4.0 server installation help
im back..
t'was really a hardware specs problem.
i tried using an "old" pc and the installation went fine..
btw, i tried to use the command "winnt /b" to run the setup.
this will copy all setup files in the HD instead of prompting you to insert the floppy disks..saved me a lot of time shifting from 1 disk to another.
thanks again for all the help :wave: