How to send and receive message in single form and with two winsock Controls

Dear friends

I want to develope a single form which can perform as local and remote host simultaneously, is it possible if yes then please tell me how. Basically what i am doing, that i set winsock.localport = 15151 and winsock.listen on form load event.

when any user want to send message to any other user i wrote these code

if user = 'aa' then
winsock.remotehost = "192.168.0.2"
if user = "bb" then
winsock.remotehost = "192.168.0.3"
endif
winsock.remoteport = 15151
winsock.connect

it is not working , where i am mistaking

I don't know why it doesn't work, because I haven't seen your code, but this works :
Add 2 command buttons and 2 winsock controls to a form and paste the following code :

VB Code:

Private Sub Command1_Click()
    Winsock2.Connect "192.168.0.2", 11151  '' local IP address
End Sub
 
Private Sub Command2_Click()
    Winsock2.Close
End Sub
 
Private Sub Form_Load()
    Winsock1.LocalPort = 1151
    Winsock1.Listen
End Sub
 
Private Sub Winsock1_ConnectionRequest(ByVal requestID As Long)
    Winsock1.Close
    Winsock1.Accept requestID
End Sub
 
Private Sub Winsock2_Connect()
    MsgBox "Success"
End Sub