Projectile motion [theory]

In my westerngame I did it pretty simple. The gun shoots straight forward, and you can shoot 150m. But a real bullet doesn't shoot like that. Let me take an AG3 for example, since that is the gun I have used the most.

You shoot the bullet out in one height. Then the first 30 meters it is a pretty straight line. Then it will start to go upwards, and after 115m it is 8cm higher then where it started, then after 200m it is at the same height as it started, and then it will slowly go down to the ground.

Now the problem is to adapt this to the game. Because the bullet will move in about 790m/s. And it can last for up to 4000m. If I have calculated right (lets say you have 30frames per sec) then it will move about 26m the first frame. So now is the problem. What would be the best way to do this:

1: Check where the bullet was last frame, and make a line from the last point, to the point it is NOW, and check to see if it penetrated through something.

2: First check if it passed through a surface (xy/yz) where someone/something is, and if it did then calculate the distance, and then check in a look up table for the height of the bullet at that point, and check if it did hit the polygon/mesh.

3: Any other good solutions?

I'm taking it the bullet moves upwards becasue of air resistance?

Ignoring resistance

a projectile will begin to fall after it is released (or fired) from a height above ground with no upward velocity following a half n shape

or if it has an upward velocity it will travel to its max height and then begin to fall

in both cases the horizontal velocity remains constent!

But im guessing you knew all that, i've just done some physics work so it was on my brain!

now including air resistance i'm assuming what you tell me is true about the bullet moving up ;)

my method would be your first suggestion to plot the route of the bullet or to plot points every 10 frames or at set intervals and draw a line from each then if the line passes over an object you know someone or somthing got hit :)

but then again i've never seen this sort of deatiled physics ina game , maybe you best just 'ignoring' air resistance or ignoring the upward flight and just concentrate on it moving horizontally and falling :)

hope i helped you out anyways

No it is not because of air resistent....how the hell can a bullet move upwards because of air resistent. If it goes perfectly straight forward, then the air resistent will be 180deg on that, and that will only slow it down, not pull it up.


Well to be honest I have never been 100% why diffrent guns do this. When I first joined the army I thought it was because of the spin the bullet gets in the pipe. But I have later been thinking a bit about that too (why shold it move upwards beacuse of that, why not down or to the side). So I guess it is because the sight is made that way compared to the pipe. Because that way you will get the "straight" firing line to be longer then if it didn't.




PS: An average person in war/combat is getting shot on 200m distance.

The army NoteMe eh? Good work. I'm joining the recruits soon but only for the reserve...I do not have the attention span to stay focused for a year and a half to join the regulars yet. So the reserve takes me depending on the session every tuesday and saturday or for 21 weeks straight...

Anyway!!

As for the bullet gaining an uplift as in comes out of the barrel.

One would think that could only happen if the bullet was initially fired at maybe an angle like 91...So it takes awhile for it to gain height. But that is not that case.

One would also assume that the bullet comes out so fast that it is nearly uneffected for the first few ms in air by anything.

See, it is the fact it is spinning as it comes out. The shape of the bullet gives it a perfect cut through the air with almost 0 resistance, but there is some...Pretending there is no air resistance then it is simply the fact is it spinning.

My gym teached back in high school used a football as an example to a bullet...Although throwing a football in a frictioness/air resistanceless environment is impossible. He showed us that throwing it practically straight would causes it to gain height near the middle of balls fleight, that effect was only noticed when the ball was in a very fast proffesional spin.

I do not know the numbers or the calculations to prove this. But it is the fact that it HAS to arc somewhere if it is spinning in its own centra-fuse sorta speak.

ok just been looking into this idea and becasue the projectile falls from the moment it laves the barrel the actuall gunsight takes this into account so when you aim for a target it willa ctually shoot just above that to compensate for the fall... thats the only reason i can think of...

When I was 18, I was about to join the Airforce. At that time though, I met a recruiter and everything and unfortunately I only had a GED, which would cause them to put me anywhere they would want me to rather than me having a choice of what part of the Airforce I would want to go. Not to mention it would not allow me much time to live the life I'm having now. The majority of my time would be for them rather than myself. So I decided not to go.

Quote:

---

Originally posted by Pino
ok just been looking into this idea and becasue the projectile falls from the moment it laves the barrel the actuall gunsight takes this into account so when you aim for a target it willa ctually shoot just above that to compensate for the fall... thats the only reason i can think of...

---

Yeah, that was what I tried to say too as my second explenation....

How did this thread end up about talking about military....now back on topic..:)