newbie concatenation issues

Hi all,
I'm writing a VB program for a school project, and I have what I think is a very simple question.

I have 13 arrays, each labeled SensorArray1, SensorArray2, etc. What I want to do is make a FOR loop from i=1 to i=13 that will read or write data to the arrays. i.e. SensorArrayi = xxxxx. What is the syntax to tack that "i" on the end of SensorArray? Is it possible? please help....

Adam

Can you give some more information? like what is to be stored in the arrays? I'm thinking you should create an array called Sensors(13) and you can store your data in each of them.

OR you create your own class (what I would do) and in each sensor element, have the properties assigned.

I am just storing decimal numbers in the arrays. I had an earlier problem by using a 2 dimensional array, Sensors(13, X) because I need to dynamically change the size of each array element, as these arrays hold data for a chart, and depending on the amount of data to be input will depend on the size of the array. The way I have it now works, except I'd like to save some code by just adding this "i" on the end of SensorArray, if that's possible. Thank you for your fast reply! Any more info would be great!

Adam

well, if it was ME, I would create a class, "Sensor", and give it properties:

xCoord
yCoord

at minimum.

then, you can declare an array of them:

dim Sensor(13) as Sensor

then, you could start a loop:

VB Code:

dim intCount as integer = 0
 
for intCount = 0 to 13
   Sensor(intCount) = new Sensor
    with Sensor(intCount)
        .xCoord = VALUE
        .ycoord = VALUE
next intCount

See how that works? Of course, you could just dim Sensor() with any number but I used 13 cause you said you had 13.


Hope that helps!!

THANK YOU, THANK YOU, THANK YOU!!!! I am forever in your debt. I didn't know how to make a class before, and that makes so much sense now!! Too bad I didn't know that a few months ago when I took on this project...there's only 1 week left now. Thank you again. It works perfectly.

Adam

Hi,

To answer your question, No you cannot further identify the array by trying to add a variable to the end of it.

Your previous idea of using a 2 dimension array should work OK. The varying size of the data to be input does not affect this.

As an alternative to that and Andy's suggestion, you could use a collection of the array, accessing them by way of the index property.