Be need'n some creative programmers here...

Allright,

Think of any control that has a click event but does not have a doubleclick event...

I need youz to think of as many possible ways to mimic a double click event for this control...

have a good one :)

Use the API to get the interval for the double-click (you can set it manually in the mouse control panel applet)
As soon as there's a click, set a timer to that interval and when that time is passed and there hasn't been clicked again, you know they didn't double-click...

The 0.2 should be replaced by the click time as specified in the control panel (but i was to lazy to look it up :) )

Code:

---

Private Sub Command1_Click()
    Static dClick As Double
    If dClick = 0 Then
        'First Click"
        dClick = Timer
    ElseIf dClick + 0.2 > Timer Then
        'Second Click inside timeframe"
        MsgBox "Yeehaa"
        dClick = 0
    Else
        'Second Click outside timeframe"
        dClick = 0
    End If
End Sub

---

------------------

Vincent van den Braken
EMail: [email protected]
ICQ: 15440110
Homepage: http://www.azzmodan.demon.nl

with the first click, start a timer, with a second click, stop the timer, use a timer with a fast interval, and make it increment a counter on every cycle. if the counter is below a certain number, BINGO!.

------------------

Wossname,
Email me: [email protected] :)

Azzmodan's looks like the best way to do it..
But it's a little buggy some of the time..

Sometimes the double click does not seem to get registered...

[This message has been edited by Inhumanoid (edited 12-08-1999).]