Adding Controls to Forms at Runtime

Hi is there a way of adding controls to a form at runtime. Example if you decide you want 2 buttons you can create them in your code, or if you want 20 you can do the same. The only way I have thought of so far is to have 20 buttons on the form and if you only want 2 making the other 18 invisible.

Thanks

You can create controls using a Control Array. For example, place a CommandButton on a form, with the Index property set to 0. This code will loop through and create 20 command buttons.

Code:

---

Private Sub Form_Initialize()

For i = 1 To 20
Load Command1(i)
Command1(i).Move 0, 0 + (480 * i)
Command1(i).Visible = True
Next i

End Sub

---

If you would like to create them from scratch, I know there is a method to do it, but it can only be done in VB6
I do not know the syntax for it either.

Hold on a sec, I knew I had the syntax for it but I didn't have it on my this computer. I booted up my old P166 computer and found this for you. This method for adding controls is only possible in VB6.

Make a Form with 1 CommandButton on it. Place the following code into it.

Code:

---

Private Sub Command1_Click()

  Controls.Add "VB.CommandButton", "cmdNewButton"
  Me!cmdNewButton.Move 0,0
  Me!cmdNewButton.Caption = "PRESS"
  Me!cmdNewButton.Visible = True

End Sub

---

I hope this helps you.

[Edited by Megatron on 05-18-2000 at 06:20 PM]

Thankyou as I was in a bind :)