Linepaint:


Move mouse, to position the cursor and indicator. Right-click to set the indicator to draw mode. While

in draw mode, Left-click to place the start of a line, move mouse to another position and Left-click again

to place the end of the line segment. You can continue to do this until you Right-click again, where

you unset the indicator from draw mode.



Press Numpad "+" to increase the grid size and Numpad "-" to decrease the grid size. The grid size is

increased and decreased by 16 pixels. This offsets the indicator position relative to the default size.



Press "C" to turn the cursor off or on. There is a slight difference in the feel of the drawing with or

without the cursor.



Press "G" to turn the grid visibility off or on.



Press Numpad "5" to center the image and Numpad "7" to place image in the top left corner of the canvas.



Press "O" to open an image. The image will be edited.



Press "S" to save the image. The image will be saved as a transparent PNG of lineart.



NOTE: You can not place a line in the outside most squares (1 square margin) of the image, regardless

of the scale.

On precision: Each square is 1 pixel center based. That means at the the default, 1 square is 33 pixels

from the left edge to the right edge (inclusive). ie. 4 squares that are 32x32 at default size would

add up to 128 + 1 = 129 pixels wide.