Important question

[netSurfer]

I was asked to make a program that would allow a user to enter measurements. What I want to do is to take an exisitng pattern, change it using these measurements and print it out. Because editing an exisitng patteren would be harder, I want to redraw the pattern using a set of coordinates. The measurements would only change certain coords. I think I know how to do it, but I don't know if A) there is a control that will allow me to do this or b)if it is even possible. Can any one help or recommend a control to use? If I'm not that clear, please feel free to email me at [email protected]. Thanks.

[netSurfer]

I found a control I can use. It's called VSview - it has a control called VSDraw. It's from VideoSoft. A friend who uses it says it would work.