This may sound really lame, even dumb?? My problem is described below: Can someone tell me what i'm doing wrong.....

1) Made App. Made an EXE. Used PDW to comple and run in lab. App is OK, no problems.

2) Made some changes to my app. Made EXE. Used PDW again - used setup.exe, as before to load on computer in lab again, BUT the app shows OLD app, no changes......

3) So i changed the name of the .vbp and erased the first one, now i erased the old .exe, made a new one.......Used PDW again......this time i checked the support folder and pressed the NEW .exe.....it looked OK???? Now i used the setup.exe to place on same computer in lab.......Still i get the OLD exe??? Can someone PLEASE help me....what am i doing wrong??


QUESTIONS:

Should i not be able to make changes to my app. then make my exe and should it not show up when i redeploy it???

Is it better to make the .exe in VB6, or let it compile it with the PDW, did this too, same thing......??? please explain....probably doing something wrong.....1st time compile is always OK